JUNGLE JUMPAROO CARE

  • To inflate your Inner Tube, you will need a standard air compressor, to ensure proper inflation we recommend using the start\stop method; small burst of air then stop, continue until full. This keeps the tube round and helps the air disperse within the tube evenly. Tube will be firm to the touch, there is no PSI reading on the tube since there is not an outer tire. The tube will stand about 13-15 inches high when properly inflated.
  • During inflation If you notice any asymmetry in your tube remove any air in the tube and re-inflate slowly using the stop and start air flow method to prevent bulging.Due to the heavy rubber compound it can take a few weeks for your tube to break-in and may require more air, we recommend filling the tube slowly and adding more as needed. Over inflation of the tube will decrease the lifespan and can also cause bulging.
  • If you encounter a slow leak in your new inner tube it is likely due to the inner valve stem core, in shipping sometime this can become loose. If this part is not tightened all the way it will allow air to slowly leak over time. Use a small part of tweezers or the valve tool that came with your Jungle Jumparoo to tighten this part by turning the inner pin in the valve stem clockwise (to the right) until it stops. You can also remove this part to deflate the inner tube quickly by unscrewing this part counterclockwise (to the left).
  • The Jungle Jumparoo Tube has been specifically tested to withstand the impact of jumping and is made from the heaviest rubber compound on the market and contains no additives that cause premature rubber rot. The compound contains a double UV protection for use outdoors. However, there are a few key steps you can take to ensure the longevity of your Inner Tube.
    • Keep the Jungle Jumparoo Inner tube out of direct Sunlight.
    • Cover the Inner Tube with the All-Weather Cover or a Tarp when not in use.
    • Remove some air from the tube in the hot summer months
    • To protect your Inner Tube over time avoid the following:
      • Abrasive or corrosive chemicals, such as pool treatment chemicals, motor oil, and industrial cleaning solutions
      • Excessive or direct sunlight that exposes the Inner Tube to harmful UV rays
      • Extremely low temperatures
      • High temperatures
      • Long periods of disuse (such as seasonal storage)
      • Under inflation
      • Over inflation
      • Inflation that causes bulging
    • Use a UV protectant on your inner tube to increase the lifespan of the tube
    • Overinflation, storage in direct sunlight and improper inflation which caused bulging is not covered by warranty and will significantly decrease the lifespan of the tube. It is recommended that air be removed from the tube during hotter months. 
  • Inspect and tighten all bars and bolts as needed
  • You may also use a product called “Loctite” in the threads of your Jungle Jumparoo if you find the bars are not staying threaded after a single use 
  • Visually inspect the inner tube for proper inflation.
  • Check for any signs of visible damage or wear to the tube.
  • Tighten all hardware
  • Check all bolts and set screws to ensure they are screwed together tight and properly, set screws should be flush with bar
  • Replace any missing bolts or set screws as needed
  • Check tube for wear or rubber rot, add or remove air as needed for proper inflation
    • Many people do not understand why their tube will suddenly not hold air after being packed away all winter long, the answer is simple. When rubber is not is use it begins to breakdown causing rubber rot. The best thing you can do to prolong the use of your tube is to use it as often as possible!
  • Use a UV protectant on your inner tube to increase the lifespan of the tube 
    • There are various products on the market, this is simply one we have use personally
  • If using the Jungle Jumparoo outdoors we recommend wiping the Jungle Jumparoo down with CRL or a similar product then applying a clear sealant coat on the powder coating every season to seal any cracks or wear that may developed over time and use.
  • Bring the Jungle Jumparoo indoors at the end of the outdoor season, or when temperatures drop below 40 degrees 
  • Using the Jungle Jumparoo year round will increase the life of your Inner Tube substantially
  • If using the Jungle Jumparoo outdoors we recommend wiping the Jungle Jumparoo down with CRL or a similar product then applying a clear sealant coat on the powder coating every season to seal any cracks or wear that may developed over time and use.
  • Leaving the Jungle Jumparoo outdoors in extreme temperatures can cause the powder coating to chip and will drastically reduce the lifespan of the tube even when using the All-Weather Cover.
  • The Jungle Jumparoo Tube cover is not UV resistant.
  • We highly suggest keeping the tube cover covered by a tarp or All-Weather Cover when not in use.
  • If necessary wash the tube cover by hand with a neoprene wash and hang to dry.